There are three methods for welding welding bolts:

Jul 18, 2022

Leave a message

The first is stable arc bolt welding. Between the end of the bolt and the workpiece, a stable arc process is generated. The arc acts as a heat source to form a molten pool on the workpiece, and at the same time, a molten layer and a plastic zone are formed at the end of the bolt. The bolt is clamped in the welding torch, relying on the spring pressure in the welding torch. or other mechanical pressure to press the bolt into the molten pool, and extrude part or all of the molten metal out of the molten pool into the ceramic ring forming groove, thereby forming a recrystallized plastic connection or a recrystallized and recrystallized mixed connection joint. The power source for such bolt welding is generally arc welding rectifiers (controllable and uncontrolled rectifiers), welding inverters or DC arc welding generators with reduced volt-ampere characteristics. Like electrode arc welding, arc discharge is a stable and continuous arc process. Stable arc bolt welding is also known as arc bolt welding.

The second type is unstable arc bolt welding. The difference with the former is that the power supply for the arc is a capacitor bank. The capacitor discharges between the end of the bolt and the workpiece to realize bolt welding. Because the capacitor discharge is an unstable arc process, that is, the arc voltage and the welding power source change instantaneously, and the process is uncontrollable. This unstable arc bolt welding is generally referred to as capacitor energy storage bolt welding or capacitor discharge bolt welding. And because the center of the bolt end welded by this method must be processed with a convex point, it is also called tip discharge bolt welding.

The third type of arc bolt welding is called short cycle bolt welding or short time bolt welding. The welding arc is modulated by the current waveform and consists of two parts, the smaller pilot arc current and the larger welding arc current. Therefore, it is a short-term stable or unstable arc bolt welding. The power supply for short-cycle bolt welding is generally powered by two parallel power supplies to supply power to the pilot arc and the welding arc respectively. It can be two arc welding rectifiers (controllable or uncontrolled), or it can be a rectifier and a capacitor bank. Only when an inverter power supply is used can it be paralleled without dual power supplies.


Send Inquiry