How to properly install flange nuts?

Oct 03, 2025

Leave a message

Carbon Steel Hexagon Hex Nut

1. Preparation
Surface Cleaning: Thoroughly remove oil, rust, and impurities from the flange, nut, and fittings, ensuring the contact surfaces are smooth and undamaged.
Inspect Accessories: Confirm that the nuts and bolts match specifications (e.g., M10-8.8), that the gasket is the same size as the flange, and that there are no deformation or cracks.
2. Installation Steps
Positioning and Alignment:
Place the gasket accurately on the flange sealing surface, ensuring center alignment.
Align the two flanges so that the bolt holes completely align to avoid deformation caused by forced insertion.
Pre-tighten the bolts:
Preliminarily tighten the bolts in a symmetrical sequence (e.g., cross-tightening), ensuring that 2-3 threads are exposed at each end of the nut.
Use a short wrench or pre-tighten manually to check for uniform flange clearance. Staged Tightening:
Apply torque gradually in three steps (e.g., 50%, 80%, and 100%), tightening each time in diagonal order to avoid excessive force on one side.
The final torque must meet the standard value (e.g., approximately 39 N·m for an M10 bolt with grade 8.8), with a tolerance of no more than ±10%.
3. Key Considerations
Anti-Loosening Measures:
In vibration environments, use serrated flange nuts or anti-loosening washers.
For stainless steel or high-temperature environments, apply molybdenum disulfide grease.
Inspection and Maintenance:
After installation, use a torque wrench to recheck all bolts to ensure consistent torque.
Regularly check flange clearance and bolt looseness, especially for equipment subject to frequent vibration.
4. Special Scenarios
Automotive flanges: Use specialized forged nuts (e.g., grade 10) for securing. Hub nuts should be tightened in a diagonal order. Industrial pipelines: The bolts must be in the same direction, the nuts must be flush with the bolt ends, and force tightening to eliminate skew is prohibited.

 

Send Inquiry