①Earthquake
First, shake the rusted screw with force, do not force it with a wrench. The rusted screw can't be screwed out even if you screw it hard, because the product material and the screw are already rusted inside, and it is very strong. Forcibly screwing the screw may cause the screw to slip or the cross groove to be damaged. If it is a hexagon socket, it may cause damage to the socket socket. If we shake it first, we can shake off some of the rust first. The rust on the key parts has been shaken off, and it will not be so laborious to screw it.
②Knock
Tap the rusted stainless steel nut with the edge of the square-top hammer, it is easy to loosen the nut. For example, the nuts of the fixing bolts at the two ends of the pedals of a bicycle can be tapped on the nuts according to the thickness and metal structure of the pedals. The nut at the cast iron part can be slightly stronger, and the plastic part should be tapped lightly. If that doesn't work, hit the nut with a hammer in a circle in the direction.
③Boil
Some screw embroidery is very serious, and the above method still does not work, you can use "fire attack". Use a gas welding oxidizing flame to fully grill the screws and nuts, and then drip a little oil on the red-hot screws. The purpose of heating the screw is to heat the screw to expand. The purpose of dripping oil is to make the screw shrink rapidly when it is cold, increase the gap between the screw rod and the stainless steel nut, and the nut can be unscrewed after the oil flows in. However, use this method with caution if there are plastic devices nearby.
④Rush
The top of the stainless steel screw of some devices is corroded and out of shape, and it cannot be removed with a wrench and wire cutters, and the impact method can be used. Start by hitting a v-groove vertically on the top of the screw with a hammer and a flathead screwdriver. Then, adjust the angle of the punch and strike in the direction the screw is unscrewed. After loosening, the screw can be unscrewed with wire cutters. This method can also be used to unscrew the screw with wire cutters when the "one" or "cross" screw is sliding.
⑤Welding
When disassembling the device, it is not uncommon for the screws to be broken. For screws with broken tops, electric drills are generally not used, because the wire holes will be drilled if you are not careful. A better way is to weld a long piece of iron to the broken wire. The section of the iron block is determined by the diameter of the stainless steel screw.
