Analysis of Four Development Stages of Tapping Screws

Jan 13, 2022

Leave a message

1. The first stage - ordinary Tapping screws

It is a direct product of early sheet metal screws. Therefore, it is also called "metal sheet screw", which is mainly used for connecting sheet metal channels of heating and ventilation systems. When screwing it into the prefabricated hole, the metal material close to the hole is displaced, and at the same time, the metal material is pushed into the space between the screw threads, thereby forming an internal thread connected with the screw. Therefore, ordinary Tapping screws, also known as "thread forming Tapping screws". This is the earliest, most basic and most widely used Tapping screws.


2. The second stage - self-cutting Tapping screws

Due to the threads of ordinary Tapping screws, threads can only be formed on thin metal sheet materials with relatively good toughness. It cannot be applied to thicker materials, or materials that are harder, brittle and less deformable. So engineers and technicians developed Tapping screws with cutting grooves or cutting edges at the end of the screw shaft—self-cutting Tapping screws. When this improved Tapping screw is screwed into the prefabricated hole, the screw can cut out the thread that connects with itself like a tap. In this way, a new type of Tapping screws—self-cutting Tapping screws was born. This is the second stage of the development of Tapping screws.


3. The third stage - self-extrusion Tapping screws

In the early 1950s, fastener engineers and technicians developed a new generation of Tapping screws—self-extrusion Tapping screws based on the cold forging design principle of taps and applied this principle to the design of Tapping screws. . Engineers designed the threaded rod (including the thread) and shank end for this type of screw. The screw of this kind of screw is usually triangular, and the screw exerts intermittent and periodic pressure on the connected parts through its thread crest, rather than on the flank of the entire thread, thereby forming an internal thread. By concentrating and limiting the forming pressure, the adjacent compressed material flows more easily and better fills (or squeezes) the flanks and bottoms of the Tapping screws. Moreover, it is precisely because the metal material of the connected piece is embedded that an "inner tenon" is formed on the inner hole of the connected piece, which forms resistance to screwing in or out of the screw. Therefore, self-extrusion Tapping screws have high locking performance. Therefore, it is also called "self-tapping locking screw".


4. The fourth stage - self-drilling Tapping screws

The Tapping screws produced in the above three stages have one thing in common: prefabricated holes must be processed in advance on the connected parts. This is also the common weakness of the above three Tapping screws. After statistics, we know that among the various items that constitute the assembly cost, the highest one is the processing of prefabricated holes. Moreover, the prefabricated holes that need to be processed for the above three Tapping screws are different for the three screws with the same nominal diameter. Moreover, the tolerance range of the corresponding prefabricated holes must be strictly controlled. Otherwise, the connection effect after screwing in will be greatly reduced. Thus, in the early 1960s, fastener engineers developed "self-drilling Tapping screws", a type of Tapping screws with a drill bit shape at the end of the Tapping screws. Since there is no need to process prefabricated holes in advance, drilling, cutting, tapping, and tightening can be performed in one step. Reduce the total assembly cost, this is the fourth stage of the development of Tapping screws: self-drilling Tapping screws.


Send Inquiry